|
|
| Remove the filter from the designated slot and Disconnect the power supply before servicing. |
|
|
|
| Place the filter on a flat surface. Open all 4 pop-up corners and remove used media pads. |
|
|
|
| Slide a plain media pad (see fig. b) under the powerbar (see fig. f). Place the Electro-fibre media pad FIBRE SIDE DOWN on to and flush with plain media pad (see fig. a). | |
|
|
| Make sure media is not sandwiched between the two panels (see fig. c), then close all 4 pop-up corners. | |
|
|
| Reconnect the power and place the filter back into the designated slot. |
| 1. YOUR LOCAL CONTRACTOR | |
| 2. DIRECT FROM InnerEco: | |
tel: 1-800-565-5326 |
|
fax: 1-800-665-6889 |
|
email: customerservice@cimatec.com |